Sets the pixels in the specified rectangle on the device

#include <WinAPIGdi.au3>
_WinAPI_SetDIBitsToDevice ( $hDC, $iXDest, $iYDest, $iWidth, $iHeight, $iXSrc, $iYSrc, $iStartScan, $iScanLines, $tBITMAPINFO, $iUsage, $pBits )

Parameter

$hDC	Handle to a device context.
$iXDest	The x-coordinate, in logical units, of the upper-left corner of the destination rectangle.
$iYDest	The y-coordinate, in logical units, of the upper-left corner of the destination rectangle.
$iWidth	The width, in logical units, of the image.
$iHeight	The height, in logical units, of the image.
$iXSrc	The x-coordinate, in logical units, of the lower-left corner of the image.
$iYSrc	The y-coordinate, in logical units, of the lower-left corner of the image.
$iStartScan	The starting scan line in the image.
$iScanLines	The number of DIB scan lines.
$tBITMAPINFO	$tagBITMAPINFO structure that contains information about the DIB.
$iUsage	The type of colors used. (either logical palette indexes or literal RGB values). The following values are defined:     $DIB_PAL_COLORS     $DIB_RGB_COLORS
$pBits	A pointer to the color data stored as an array of bytes.

Rückgabewert

Success:	the number of scan lines set. 0 - Otherwise.
Failure:	sets the @error flag to non-zero (GDI_ERROR).

Bemerkungen

If the driver cannot support the JPEG or PNG file image passed to SetDIBitsToDevice,
the function will fail and return GDI_ERROR.

Siehe auch

Suche nach SetDIBitsToDevice in der MSDN Bibliothek.