Retrieves information about the system power capabilities
#include <WinAPISys.au3>
_WinAPI_GetPwrCapabilities ( )
| Success: | The array that contains the following information: [0] - If True, there is a system power button. [1] - If True, there is a system sleep button. [2] - If True, there is a lid switch. [3] - If True, the operating system supports sleep state S1. [4] - If True, the operating system supports sleep state S2. [5] - If True, the operating system supports sleep state S3. [6] - If True, the operating system supports sleep state S4 (hibernation). [7] - If True, the operating system supports power off state S5 (soft off). [8] - If True, the system hibernation file is present. [9] - If True, the system supports wake capabilities. [10] - If True, the system supports video display dimming capabilities. [11] - If True, the system supports APM BIOS power management features. [12] - If True, there is an uninterruptible power supply (UPS). [13] - If True, the system supports thermal zones. [14] - If True, the system supports processor throttling. [15] - The minimum level of system processor throttling supported, expressed as a percentage. [16] - The maximum level of system processor throttling supported, expressed as a percentage. [17] - If True, the system supports the hybrid sleep state. [18] - If True, the system supports allowing the removal of power to fixed disk devices. [19] - If True, there are one or more batteries in the system. [20] - If True, the system batteries are short-term. Short-term batteries are used in uninterruptible power supplies (UPS). [21] - The lowest system sleep state (Sx) that will generate a wake event when the system is on AC power. [22] - The lowest system sleep state (Sx) that will generate a wake event via the lid switch. [23] - The lowest system sleep state (Sx) supported by hardware that will generate a wake event via the RTC. [24] - The minimum allowable system power state supporting wake events. |
| Failure: | Sets the @error flag to non-zero, call _WinAPI_GetLastError() to get extended error information. |
None.
Suche nach GetPwrCapabilities in der MSDN Bibliothek.
#include <Array.au3>
#include <WinAPISys.au3>
Local $aInfo[25][2] = _
[['Power button', 0], _
['Sleep button', 0], _
['Lid switch', 0], _
['S1', 0], _
['S2', 0], _
['S3', 0], _
['S4', 0], _
['S5', 0], _
['HIBERFIL.SYS', 0], _
['Wake', 0], _
['Video display dimming', 0], _
['APM BIOS', 0], _
['UPS', 0], _
['Thermal zones', 0], _
['Throttling', 0], _
['Throttling min level', 0], _
['Throttling max level', 0], _
['Hibernation', 0], _
['HDD power down', 0], _
['Batteries', 0], _
['Batteries short-term', 0], _
['AC lowest wake state', 0], _
['Lid lowest wake state', 0], _
['RTC lowest wake state', 0], _
['Minimum device wake state', 0]]
Local $aData = _WinAPI_GetPwrCapabilities()
If Not @error Then
For $i = 0 To UBound($aInfo) - 1
$aInfo[$i][1] = $aData[$i]
Next
Else
Exit
EndIf
_ArrayDisplay($aInfo, '_WinAPI_GetPwrCapabilities')