Hallo,
bin schon den ganzen Morgen dabei,
das Problem zu lösen! Ohne Erfolg!
Kann man in einer Gui ein Foto/Button... machen
und auf dieses Foto ein transparentes Label setzen?
Grüße
Ilse
Hallo,
bin schon den ganzen Morgen dabei,
das Problem zu lösen! Ohne Erfolg!
Kann man in einer Gui ein Foto/Button... machen
und auf dieses Foto ein transparentes Label setzen?
Grüße
Ilse
Mit transparent meinst du den Hintergrund des Textes oder?
so in etwa?
#include <GUIConstantsEx.au3>
#include <StaticConstants.au3>
#include <WindowsConstants.au3>
$Form1 = GUICreate("", 500, 400)
$Pic1 = GUICtrlCreatePic(@ScriptDir & "\test.jpg", 0, 0, 500, 400, BitOR($SS_NOTIFY,$WS_GROUP,$WS_CLIPSIBLINGS))
GUICtrlSetState(-1, $GUI_DISABLE)
$Label1 = GUICtrlCreateLabel("Test", 120, 120, 220, 120)
GUICtrlSetFont(-1, 80, 400, 0, "MS Sans Serif")
GUICtrlSetBkColor(-1, $GUI_BKCOLOR_TRANSPARENT )
GUISetState(@SW_SHOW)
While 1
$nMsg = GUIGetMsg()
Switch $nMsg
Case $GUI_EVENT_CLOSE
Exit
EndSwitch
WEnd
Hallo Schnitzel,
super! Damit habe ich Stunden verbracht!
Weißt du wie man das in Koda hinbekommt?
Muß ich das bei der Form ändern?
Da ist nirgends etwas von Transparenz zu sehen. Color...
Grüße Ilse
Nö leider keine Ahnung.
Ich mach fast nichts mit Koda.
Schreib das GUICtrlSetBkColor($Label1, $GUI_BKCOLOR_TRANSPARENT ) doch einfach auserhalb der Koda-Section
das probier ich mal!
Ich check mal KODA nochmal kpl. durch
und melde mich wieder!
Eins versteh ich wirklich nicht, warum benutzen die Profis kein KODA?
Bis bald
Liebe Grüße
Ilse
P.S.
ZitatEins versteh ich wirklich nicht, warum benutzen die Profis kein KODA?
made my Day! Danke Ilse!